Izvorni znanstveni članak

Turning of high quality aluminium alloys with minimum costs

Marko Reibenschuh ; Faculty of Mechanical Engineering, Smetanova 17, 2000 Maribor, Slovenia
Franc Cus ; Faculty of Mechanical Engineering, Smetanova 17, 2000 Maribor, Slovenia
Uros Zuperl ; Faculty of Mechanical Engineering, Smetanova 17, 2000 Maribor, Slovenia

Sažetak

Turning is one of the most common metal cutting procedures used. To optimize such a cutting process, some adaptations must be made. Implementing tool wear conditioning and the use of dry cutting can significantly lower the production cost. This research focuses on the cost effectiveness of using dry cutting in comparison with the use of cutting fluids and the use of different tool geometry. A series of tests was conducted and in the end the results are given.

Ključne riječi

aluminium; cutting fluids; production costs; turning

Hrčak ID:

71816

URI

https://hrcak.srce.hr/71816

Datum izdavanja:

26.9.2011.

Podaci na drugim jezicima: hrvatski

Posjeta: 3.516 *