Skoči na glavni sadržaj

Izvorni znanstveni članak

Effect of cooling rate on microstructure of B2-NiSc intermetallics

Zhipeng Yuan ; Henan Polytechnic University
Hao Chen ; Henan Polytechnic University
Hongbao Cui ; Henan Polytechnic University
Yatao Chang ; Henan Polytechnic University
Xuefeng Guo ; Henan Polytechnic University

Puni tekst: engleski PDF 855 Kb

str. 236-242

preuzimanja: 274



Ni-50at%Sc alloy was prepared by centrifugal
casting method. Volume fraction, the actual
content of B2-NiSc and second phase Ni2Sc in
alloy were analyzed with an Image-Pro Plus
software. The cooling rates for the solidified thin
plate with thickness of 2.65mm, 1.2mm, 0.75mm
and 0.35 mm are 1164, 2570, 4112 and 8811 K·s-
1, respectively. It is found that d=0.5 mm was an
critical dimension which corresponds to an abrupt
change in the solidification rate. It is also found
that (Ni2Sc+NiSc)eutectic was dispersed at grain
boundary or between dendritic arms due to the loss
of Sc element during melting. While d> 0.5mm
(corresponding to the thin plate with thickness of
0.75mm, 1.20mm and 2.65 mm), the solidification
structure consists of primary phase B2-NiSc and
(Ni2Sc+NiSc)eutectic. While d < 0.5mm
(corresponding to the thin plate with thickness of
0.35 mm), the solidification structure is composed
of fine globular B2-NiSc and relatively small
amounts of (Ni2Sc+NiSc)eutectic. Based on the phase
volumetric analyzing of the microstructure with an
Image-Pro Plus software, the loss of Sc element
during melting was about 3.01~3.10 at%. The
eutectic NiSc in the lamellar eutectic structure
together with the primary phase B2-NiSc form a
larger single phase NiSc, while Ni2Sc with the form
of particles is distributed on the grain boundaries
after (970 ℃, 72 h) homogenization heat

Ključne riječi

centrifugal casting, B2-NiSc, microstructure evolution, rapid solidification, heat treatment, (Ni2Sc+NiSc)eutectic

Hrčak ID:



Posjeta: 530 *