Tehnički vjesnik, Vol. 27 No. 6, 2020.
Stručni rad
https://doi.org/10.17559/TV-20190513073712
Numerical Modelling of Y Joints of Trusses Made of Steel Hollow Sections
Srđan Živković*
; Faculty of Civil Engineering and Architecture-University of Niš, Aleksandra Medvedeva 14, Niš, Serbia
Nenad Stojković
; College of Applied Technical Sciences Niš, Aleksandra Medvedeva 20, Niš, Serbia
Dragana Turnić
; Faculty of Civil Engineering and Architecture-University of Niš, Aleksandra Medvedeva 14, Niš, Serbia
Marko Milošević
; Innovation Center University of Niš, Faculty of Civil Engineering and Architecture-University of Niš, Univerzitetskitrg 2, Niš, Serbia
Sažetak
The use of welded structural hollow sections in civil engineering is relatively new. Constructing and dimensioning joints of steel trusses made of welded structural hollow sections requires a more specified approach, compared to traditional joints, achieved by gusset plates. Stress and local deformations at the contact between elements are non-linear and very complex. In this paper, the FEM modelling of the Y-joint was performed, accounting for the non-linear behaviour of steel. The ultimate bearing capacities of the joint were determined numerically, by applying different failure criteria. The results showed very good agreement with the experimental data.
Ključne riječi
hollow sections; steel modelling; steel trusses; Y joints
Hrčak ID:
248262
URI
Datum izdavanja:
19.12.2020.
Posjeta: 1.452 *