Metalurgija, Vol. 61 No. 3-4, 2022.
Izvorni znanstveni članak
Effect of feed rate on forming quality of cross wedge rolling of gear shaft teeth
X. G. Chen
; Ningbo University, School of Mechanical Engineering and Mechanics, Ningbo, China
X. D. Shu
; Ningbo University, School of Mechanical Engineering and Mechanics, Ningbo, China; shuxuedao@nbu.edu.cn
Q. J. Lian
; Ningbo University, School of Mechanical Engineering and Mechanics, Ningbo, China
Sažetak
In order to improve the forming quality of cross wedge rolling of gear shaft teeth, this paper adopts the single factor research method and uses DEFORM - 3D software to carry out the finite element simulation of the rolling process with different feed rate dies.The results show that the total feed rate of 2,75 mm is the most appropriate, and the tooth top defect of rolled piece gear can be repaired under this condition. The feed rate in the first stage is more important than that in the other stages, and the suitable range of it is 1,0 mm - 1,2 mm.
Ključne riječi
cross wedge rolling; gear; feed rate; forming quality; finite element simulation
Hrčak ID:
273849
URI
Datum izdavanja:
1.7.2022.
Posjeta: 813 *