Skoči na glavni sadržaj

Izvorni znanstveni članak

https://doi.org/10.5552/drvind.2022.2132

Identification of Defective Joints in Beams via Torsional Vibration

Mostafa Kohantorabi ; Islamic Azad University, Science and Research Branch, Faculty of Natural Resources and Environment, Department of Wood and Paper Engineering, Teheran, Iran
Alireza Asgari ; Islamic Azad University, Science and Research Branch, Faculty of Natural Resources and Environment, Department of Wood and Paper Engineering, Teheran, Iran
Mona Shayestehkia ; Islamic Azad University, Science and Research Branch, Faculty of Natural Resources and Environment, Department of Wood and Paper Engineering, Teheran, Iran
Mobina Kohantorabi ; Karaj Branch – Islamic Azad University, Faculty of Literature and Foreign Languages, Karaj, Iran


Puni tekst: engleski pdf 803 Kb

str. 431-438

preuzimanja: 189

citiraj


Sažetak

The determination of the shear dynamic modulus in wood product panels is of greater importance than its determination in wood beams. Yet with regards to the effect of defects on the obtained values of shear modulus, this factor is used to detect the defects and the degree of the defects. In this study, the effect of gluing defects in two joint shapes (scarf (45°) and finger joints (10 mm length and 3 mm pitch) were evaluated non-destructively using the torsional vibration method. Rectangular wood specimens with dimensions of 20 mm × 40 mm × 360 mm (R × T × L) were prepared from clear eastern beech. The joints were located at similar positions in the middle of the beams. The results showed that creating a healthy joint did not significantly change the values obtained for the shear modulus in either of the joint shapes. However, reducing the adhesion level in both types of joints caused a significant reduction in the shear modulus values. The results show that the changes in the dynamic shear modulus values in both joint types, as a result of changes in the glue coverage rating (fully, medium and low-glued joints) allows the detection of the defects as well as the degree of the defects.

Ključne riječi

joint; prediction; defect; torsional vibration; beech; adhesive

Hrčak ID:

285716

URI

https://hrcak.srce.hr/285716

Datum izdavanja:

15.11.2022.

Podaci na drugim jezicima: hrvatski

Posjeta: 480 *