Original scientific paper
https://doi.org/10.21278/brod72101
SELECTION OF WELDING CONDITIONS FOR MINIMIZING THE RESIDUAL STRESSES AND DEFORMATIONS DURING HARD-FACING OF MILD STEEL
Atilla Savaş
orcid.org/0000-0001-6900-3259
; Piri Reis University, Istanbul, Turkey
Abstract
Hard-facing process is widely used for improving the wear resistance of mild steel. During the application of hard-facing, due to high temperatures, residual stresses and deformations may occur. The tensile residual stresses may cause crack propagation on the hard-faced part. The purpose of this study is to utilise minimum computer work for minimizing these residual stresses and deformations during the hard-facing of mild steel. The fully coupled transient heat transfer and structural analysis was performed for calculations. The double-ellipsoidal moving heat source was utilised to simulate the heat input from the gas metal arc welding (GMAW). Only eight numerical simulations were performed to minimize the computer work; the grey relational analysis was used for minimizing both the residual stresses and deformations. Welding speed, welding current, and welding pattern were considered as changing parameters. At the end of the numerical and statistical solutions, it is observed that heat input should be kept minimum to minimize the stresses and deformations. But it is obvious that the heat input must provide a temperature greater than the melting point. Straight patterns always produce better results for minimizing stresses and deformations. Transverse stress at the beginning and end of the longitudinal path gets higher significantly after cooling. Cooling does not affect the total deformation.
Keywords
Hard-facing; grey relational analysis; residual stresses; deformations; moving heat source; GMAW
Hrčak ID:
252835
URI
Publication date:
1.3.2021.
Visits: 1.815 *