Skip to the main content

Strojarstvo : časopis za teoriju i praksu u strojarstvu, Vol. 53 No. 4, 2011.

Original scientific paper

Cutting Force Analysis in Face Milling Using Rotatable Central Composite Design of Experiments and Taguchi Method

Dražen BAJIĆ ; Faculty of Electrical Engineering, Mechanical Engineering and Naval Architecture, University of Split, Split, Croatia
Sonja JOZIĆ ; Faculty of Electrical Engineering, Mechanical Engineering and Naval Architecture, University of Split, Split, Croatia

Full text: english pdf 948 Kb

page 243-248

downloads: 601

cite

Abstract

This paper presents a study of the influence of cutting conditions on the cutting force components during face milling of steel 42CrMo4. Two experimental plans, rotatable central composite design and the Taguchi method with orthogonal arrays and signal-to-noise ratio, have been designed and performed on controlled machining with corresponding cutting conditions. Equations for the cutting force components, as a functions of cutting parameters, have been obtained by means of regression analysis. The Taguchi method has been used to analyse impact of cutting parameters on the cutting force components and to find optimal level of the cutting parameters. The comparison of results obtained by means of the rotatable central composite design and the Taguchi method was performed.

Keywords

Cutting forces; Design of experiments; Face milling; Regression analysis; Taguchi method

Hrčak ID:

80434

URI

https://hrcak.srce.hr/80434

Publication date:

31.8.2011.

Article data in other languages: croatian

Visits: 1.601 *