Izvorni znanstveni članak

https://doi.org/10.37798/2022714412

Corrosion Detection and Surface Repair with Coatings on Condensate Storage Tanks Internal Surfaces

Matija Guliš ; Nuclear Power Plant Krško (NEK)
Sanja Smirić ; Nuclear Power Plant Krško (NEK)
Lenart Pušnik ; Nuclear Power Plant Krško (NEK)

Sažetak

In the Nuclear power plant Krško, there are two single hull condensate storage tanks with floating diaphragm each containing up to 757 m3 of demineralized water. The main purpose of these two storage tanks is to provide a capacity of cooling water for cooling the reactor coolant system via steam generators with the use of auxiliary feedwater pumps. This is a very important function from the safety point of view and that is the reason that both storage tanks are listed as safety class 3 components. It is also possible to fill up the condensate system if other means are not available. Condensate storage tanks are subject to periodic testing and periodic inspections to determine the condition of the components. Both tanks are in operation since the start-up of the powerplant, are located outside, and are exposed to different degradation processes. There was a concern that the tanks are leaking because there were often small puddles of water near the tanks. There were no changes in the levels of tanks. The design of tanks is a single hull, so there is no indication if a small leak is present.
In the outage 2018, both tanks were emptied and examined with NDE methods to find any corrosion damage of bottom plates and any untight spots on adjacent welds.
The article is about the NDE methods that were used (Magnetic Flux Leakage, Ultrasonic and Vacuum Box inspection) to determine the condition of the floor plates and adjacent welds as well as the process of internal surface reparation with coatings. Process of coatings qualification for use in safety class components is also explained: dedication process for material up-grade from non-safety related to safety-related because CY tank linings are classified as safety-related according to RG 1.54, rev 2 and corresponding ASTM standards and NEK technical specification SP-A5001. All activities for surface repair with coatings shall comply with safety-related requirements. Also, extensive immersion tests with selected and specially defined parameters were performed in NEK chemical laboratory in order to select the most suitable coating system for surface repair of CY tank floor lining. Further details concerning immersion tests are presented below.

Ključne riječi

Corrosion; Condensate Tank; NDE; Coating; Aging Management

Hrčak ID:

305838

URI

https://hrcak.srce.hr/305838

Datum izdavanja:

15.6.2023.

Posjeta: 391 *