Izvorni znanstveni članak

Modeling research on limitation of transition zone during continuous steel casting

J. Pieprzyca orcid.org/0000-0002-7615-6082 ; Silesian University of Technology, Faculty of Material Science, Katowice, Poland
T. Merder orcid.org/0000-0002-3766-6784 ; Silesian University of Technology, Faculty of Material Science, Katowice, Poland
M. Saternus orcid.org/0000-0001-8996-1980 ; Silesian University of Technology, Faculty of Material Science, Katowice, Poland
M. Tkadlecková ; VSB - Technical University of Ostrava, Ostrava, Czech Republic
J. Cupek orcid.org/0000-0002-0013-5277 ; VSB - Technical University of Ostrava, Ostrava, Czech Republic
J. Walek orcid.org/0000-0002-0416-8228 ; VSB - Technical University of Ostrava, Ostrava, Czech Republic

Sažetak

The increase in market demand for small masses of special purpose steel forces its producers to use the technique of continuous casting with a transition zone. The article presents the results of model tests of limiting the range of the transition zone as a result of the use of an impact pad and changes in the volume of liquid steel in the tundish. A water physical model of a Continuous Steel Casting (CSC) device equipped with a two-outlets tundish was used for the research. The criterion for assessing the range of the transition zone was the value of the minimum time of complete mixing tome of the tracer in the modeling liquid, determined on the basis of the Residence Time Distribution (RTD) curves. Visualization techniques of the modeling liquid mixing process were used to identify hydrodynamic phenomena.

Ključne riječi

tundish; liquid steel flow; impact pad; transition zone; physical water model

Hrčak ID:

307368

URI

https://hrcak.srce.hr/307368

Datum izdavanja:

1.1.2024.

Posjeta: 944 *