Skoči na glavni sadržaj

Izvorni znanstveni članak

https://doi.org/10.30765/er.1520

The analysis of material removal rate of WEDM miniature gears

Ashish Goyal orcid id orcid.org/0000-0001-8058-6790 ; Department of Mechanical Engineering, Manipal University Jaipur, Dehmi Kalan, Jaipur, Rajasthan, India, 303007
Vyom Singh ; Department of Mechanical Engineering, Manipal University Jaipur, Dehmi Kalan, Jaipur, Rajasthan, India, 303007
Abhishek Patel ; Department of Mechanical Engineering, Manipal University Jaipur, Dehmi Kalan, Jaipur, Rajasthan, India, 303007


Puni tekst: engleski pdf 479 Kb

str. 59-64

preuzimanja: 177

citiraj


Sažetak

Gear fabrication in wire electrical discharge machining (WEDM) plays an important role in manufacturing industries. This paper describes the analysis and optimization of process parameters for the fabrication of spur gear on brass spur gear on brass workpiece (10cmx15cmx6mm) material by wire EDM process. The experiments were performed by using the design of experiment (DoE) approach and the material removal rate (MRR) was analyzed by response surface methodology technique. The effect of input parameters i.e. pulse on time, pulse off time and feed rate on MRR has been investigated. The surface geometry of the gears has been analysed by the Scanning Electron Microscopy (SEM). This study found that 0.4 μs for pulse on time, 60 μs for pulse-off time and 6 mm/min for feed rate provides improved material removal rate. The analysis of variance shows that pulse on time and feed rate are the significant parameters for the wire EDM process. The SEM image exhibits the capability of WEDM to machined miniature gear with a uniform distribution of regular-shaped craters and defect-free flank surface.

Ključne riječi

WEDM, miniature spur gear, material removal rate, response surface methodology, scanning electron microscopy

Hrčak ID:

255120

URI

https://hrcak.srce.hr/255120

Posjeta: 373 *