Izvorni znanstveni članak

https://doi.org/https://doi.org/10.64486/m.65.4.3

Utilization of Fine Fraction of Converter Slag in the Form of an Addition to Copper Concentrate Briquettes

Krzysztof Gargul orcid.org/0000-0001-7398-0634 ; Department of Non-Ferrous Metals, AGH University of Krakow, Al. Mickiewicza 30, 30-059 Krakow *

* Dopisni autor.

Sažetak

During the copper matte converting process, slag is produced. Owing to its valua-ble components, it is returned to the shaft furnace, where copper concentrates are smelted. Recycled slags should not contain excessive amounts of fine fractions, which reduce the permeability of the furnace charge and may be entrained with the gas stream. This study aimed to investigate the possibility of using a fine frac-tion of converter slag as an addition to copper concentrate briquettes. The results indicate that the optimal addition, in terms of briquette strength, is 6 % converter slag with a particle size of (0–1) mm. The presence of fayalite in the slag causes even such a small addition to reduce the final melting temperature by approxi-mately 30 °C compared with the slag-free charge. Consequently, copper concen-trates can be smelted with reduced coke consumption, while the resulting shaft slag exhibits lower viscosity and, therefore, reduced copper losses.

Ključne riječi

converter slag; briquettes; melting point; slag recycling

Hrčak ID:

347930

URI

https://hrcak.srce.hr/347930

Datum izdavanja:

1.10.2026.

Posjeta: 19 *