Tehnički vjesnik, Vol. 17 No. 4, 2010.
Izvorni znanstveni članak
A model for improving the flexographic printing plate making process
Dragoljub Novaković
orcid.org/0000-0002-6455-7233
; Faculty of Technical Sciences, University of Novi Sad, Trg Dositeja Obradovića 6, 21000 Novi Sad, Srbija
Sandra Dedijer
; Faculty of Technical Sciences, University of Novi Sad, Trg Dositeja Obradovića 6, 21000 Novi Sad, Srbija
Sanja Mahović Poljaček
; Faculty of Graphic Arts, University of Zagreb, Getaldićeva 2, 10000 Zagreb, Croatia
Sažetak
Thermal development process of photopolymer printing plates is one of the newest technologies in the flexographic reproduction process. It is solely based on mechanical process and thus enables the elimination of the chemical processing and drying phase from the plate making process. Taking into account that chemical processing is one of the critical problems in standardization of the plate making process, thermal development process should ensure greater quality and stability in the plate making process. This paper evaluates the specific conditions in the plate making procedure based on thermal development. Testing of the back and main exposure duration of the photopolymer plates, as well as duration of the thermal development, were the objects of this research. The thickness and hardness, as well as SEM analysis of the printing plates were performed. Characterization of the produced plates was made and new model for improving the production line of the observed flexographic plates was defined.
Ključne riječi
flexographic printing plates; quality; thermal development process
Hrčak ID:
62914
URI
Datum izdavanja:
31.12.2010.
Posjeta: 7.680 *