Prethodno priopćenje

Studies on magnesium addition to copper produced in the continuous casting process and analysis of mechanical, electrical and structural properties of obtained casts

K. Franczak orcid.org/0000-0002-0135-3700 ; AGH University of Science and Technology, Faculty of Non-Ferrous Metals, Cracow, Poland
P. Kwasniewski orcid.org/0000-0002-7826-6672 ; AGH University of Science and Technology, Faculty of Non-Ferrous Metals, Cracow, Poland
G. Kiesiewicz orcid.org/0000-0001-9518-5498 ; AGH University of Science and Technology, Faculty of Non-Ferrous Metals, Cracow, Poland
M, Sadzikowski orcid.org/0000-0002-9791-4137 ; AGH University of Science and Technology, Faculty of Non-Ferrous Metals, Cracow, Poland
W. Sciezor orcid.org/0000-0001-8974-5970 ; AGH University of Science and Technology, Faculty of Non-Ferrous Metals, Cracow, Poland
S. Kordaszewski orcid.org/0000-0002-5455-2025 ; AGH University of Science and Technology, Faculty of Non-Ferrous Metals, Cracow, Poland

Sažetak

Article presents the effect of magnesium addition to copper in the range of 0,02 – 0,5 wt. %. on the mechanical, electrical and structural properties of obtained materials. All analysed alloys were produced by horizontal continuous casting set-up in the form of 9,5 mm rods. Obtained Cu-Mg alloys were next tested for their as-cast properties via Vickers hardness analysis, electrical conductivity measurements and macrostructure observations in both cross and longitudinal section. The aim of the research was to verify the influence of the magnesium content on the properties of selected Cu-Mg alloys, which are dedicated to use in overhead railway system for contact wires and catenaries.

Ključne riječi

continuous casting; copper Cu-Mg alloys; mechanical properties; structural properties; electrical conductivity

Hrčak ID:

301031

URI

https://hrcak.srce.hr/301031

Datum izdavanja:

3.7.2023.

Posjeta: 667 *