Technical Journal, Vol. 16 No. 3, 2022.
Preliminary communication
https://doi.org/10.31803/tg-20220413112955
Influence of Infill Pattern on 3D-Printed Parts Compression Strength
Damir Godec
; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture, Ivana Lučića 5, HR-10000 Zagreb, Croatia
Karlo Križetić
; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture, Ivana Lučića 5, HR-10000 Zagreb, Croatia
Ana Pilipović
orcid.org/0000-0003-1330-6458
; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture, Ivana Lučića 5, HR-10000 Zagreb, Croatia
Abstract
Article presents analysis of the influence of infill pattern on 3D printed parts compression properties. Most of the researches from this field covered tensile 3D-printed parts properties, but for some applications compression mechanical properties are far more important. For the analysis of compression strength, 3D-printed specimens were produced by Fused Filament Fabrication (FFF) process from acrylonitrile butadiene styrene (ABS) with different shapes of infill pattern. Testing results showed that honeycomb infill pattern results with the highest compression strength. Unexpected result was the lowest compression strength of gyroid infill pattern, which must be more deeply investigated.
Keywords
Acrylonitrile Butadiene Styrene (ABS); additive manufacturing; compression strength; Fused Filament Fabrication (FFF); infill pattern
Hrčak ID:
279403
URI
Publication date:
21.6.2022.
Visits: 992 *