Prethodno priopćenje

https://doi.org/10.31803/tg-20220413112955

Influence of Infill Pattern on 3D-Printed Parts Compression Strength

Damir Godec ; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture, Ivana Lučića 5, HR-10000 Zagreb, Croatia
Karlo Križetić ; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture, Ivana Lučića 5, HR-10000 Zagreb, Croatia
Ana Pilipović orcid.org/0000-0003-1330-6458 ; University of Zagreb, Faculty of Mechanical Engineering and Naval Architecture, Ivana Lučića 5, HR-10000 Zagreb, Croatia

Sažetak

Article presents analysis of the influence of infill pattern on 3D printed parts compression properties. Most of the researches from this field covered tensile 3D-printed parts properties, but for some applications compression mechanical properties are far more important. For the analysis of compression strength, 3D-printed specimens were produced by Fused Filament Fabrication (FFF) process from acrylonitrile butadiene styrene (ABS) with different shapes of infill pattern. Testing results showed that honeycomb infill pattern results with the highest compression strength. Unexpected result was the lowest compression strength of gyroid infill pattern, which must be more deeply investigated.

Ključne riječi

Acrylonitrile Butadiene Styrene (ABS); additive manufacturing; compression strength; Fused Filament Fabrication (FFF); infill pattern

Hrčak ID:

279403

URI

https://hrcak.srce.hr/279403

Datum izdavanja:

21.6.2022.

Posjeta: 1.199 *