Skip to the main content

Engineering Review : International journal for publishing of original researches from the aspect of structural analysis, materials and new technologies in the field of mechanical engineering, shipbuilding, fundamental engineering sciences, computer sciences, electrical engin, Vol. 27 No. 2, 2007.

Preliminary communication

CONTROLL BOARD STAND FOR TRUMPF PRESSES MANUFACTURING BY METAL FORMING APLICATION

Nenad Pauletić ; Faculty of Engineering, University of Rijeka, Rijeka, Croatia
Branimir Barišić ; Faculty of Engineering, University of Rijeka, Rijeka, Croatia
Marko Kršulja ; Faculty of Engineering, University of Rijeka, Rijeka, Croatia

Full text: croatian pdf 414 Kb

page 103-111

downloads: 1.232

cite

Full text: english pdf 414 Kb

page 103-111

downloads: 960

cite

Abstract

This paper presents different software programs used in the production of a control board stand used to drive the Trumpf press. The presented approach uses different software programs for: strain energy evaluation, sheet metal preparation purposes, and the creation of NC programs. Different forming technologies were investigated in order to obtain the most appropriate control board stand parts. USt 13 (DIN 1623 T1) steel, i.e. DC 01 (EN 10130 –Cold Rolled Steel Sheet and Strip for Cold Forming) was used as the production material. The friction coefficient appearing in this research and the material flow curve (in the form of a power relationship expressed as the Hollomon-Ludwik's law) have been determined experimentally.

Keywords

sheet metal forming; control board for Trumpf presses; numerical simulation

Hrčak ID:

26345

URI

https://hrcak.srce.hr/26345

Publication date:

27.12.2007.

Article data in other languages: croatian

Visits: 3.361 *