Skoči na glavni sadržaj

Engineering Review : Međunarodni časopis namijenjen publiciranju originalnih istraživanja s aspekta analize konstrukcija, materijala i novih tehnologija u području strojarstva, brodogradnje, temeljnih tehničkih znanosti, elektrotehnike, računarstva i građevinarstva, Vol. 27 No. 2, 2007.

Prethodno priopćenje

CONTROLL BOARD STAND FOR TRUMPF PRESSES MANUFACTURING BY METAL FORMING APLICATION

Nenad Pauletić ; Tehnički fakultet Sveučilišta u Rijeci, Rijeka, Hrvatska
Branimir Barišić ; Tehnički fakultet Sveučilišta u Rijeci, Rijeka, Hrvatska
Marko Kršulja ; Tehnički fakultet Sveučilišta u Rijeci, Rijeka, Hrvatska

Puni tekst: hrvatski pdf 414 Kb

str. 103-111

preuzimanja: 1.124

citiraj

Puni tekst: engleski pdf 414 Kb

str. 103-111

preuzimanja: 802

citiraj

Sažetak

This paper presents different software programs used in the production of a control board stand used to drive the Trumpf press. The presented approach uses different software programs for: strain energy evaluation, sheet metal preparation purposes, and the creation of NC programs. Different forming technologies were investigated in order to obtain the most appropriate control board stand parts. USt 13 (DIN 1623 T1) steel, i.e. DC 01 (EN 10130 –Cold Rolled Steel Sheet and Strip for Cold Forming) was used as the production material. The friction coefficient appearing in this research and the material flow curve (in the form of a power relationship expressed as the Hollomon-Ludwik's law) have been determined experimentally.

Ključne riječi

sheet metal forming; control board for Trumpf presses; numerical simulation

Hrčak ID:

26345

URI

https://hrcak.srce.hr/26345

Datum izdavanja:

27.12.2007.

Podaci na drugim jezicima: hrvatski

Posjeta: 2.756 *